Abstract
The paper aimed to reveal, qualitatively and quantitatively, the modifications suffered by the PLA during the complex heating cycle specific to the 3D printing followed by laser marking. The obtained results showed that the melting point of the PLA decreases from 162.2oC (which is specific to PLA filament) to 153.1oC after the 3D printing process and to 149.7oC after the laser heating. The glass transition suffered the same lowering after the printing process but an important increasing after the laser heating. The elastic modulus evolution proved a decreasing of the plasticity and that is hapenning when the material suffers an increasing of its rigidity. The elongation viscosity was analyzed and its values were decreasing with the increasing of the temperature that happened on the material. The decreasing was produced by the reduction of the elasticity, when the chain branches are decreasing their length. The decreasing is more pronounced with the increasing of the temperature. The ratio between the loss modulus to the storage modulus and quantifies the way in which the PLA absorbs and disperses energy moves its peak from 65oC (curve specific to the PLA filament) to 45oC (curve specific to the last layer deposited by 3D printing process and re-heated by laser beam for marking). The peak means the lowest storage modulus, which is a measure of elastic response of a material, so the transition from glass to high elasticity moves to the lower temperatures.
Keywords: 3D printing using PLA; laser heating; relaxation modulus; crystallization; decreased plasticity; elongation viscosity