ABOUT INDEXING EDITORIAL BOARD ARCHIVES AUTHOR GUIDELINES SUBMIT PAPER NEWS, EVENTS AUTHOR'S PAGE CONTACT
Materiale Plastice
Cite as: Mater. Plast.
https://doi.org/10.37358/Mat.Plast.1964

OSIM Nr. R102356
ISSN Print 0025-5289
ISSN Online 2668-8220
Journal Metrics
* Impact factor 2019: 1.517
* 5-Year IF: 1.179
* CiteScore: 2.4
* H index: 22
Materiale Plastice - Latest Issue

Latest Issue >>>
ARCHIVES
   Volume 58, 2021
   Volume 57, 2020
   Volume 56, 2019
   Volume 55, 2018
   Volume 54, 2017
   Volume 53, 2016
   Volume 52, 2015
   Volume 51, 2014
   Volume 50, 2013
   Volume 49, 2012
   Volume 48, 2011
   Volume 47, 2010
   Volume 46, 2009
   Volume 45, 2008
   Volume 44, 2007
   Volume 43, 2006
   Volume 42, 2005
   Volume 41, 2004
   Volume 40, 2003
 
<<<< back

Materiale Plastice (Mater. Plast.), Year 2009, Volume 46, Issue 2,





Camelia Cerbu, Vasile CIOFOAIA, Ioan CURTU, AURELIAN VISAN The Effects of the Immersion Time on the Mechanical Behaviour in Case of the Composite Materials Reinforced with E-glass Woven Fabrics


Abstract:
The paper describes aspects concerning the effects of the immersion time in water, on some mechanical characteristics of some composite materials reinforced with E-glass woven fabrics. The specimens were manufactured by reinforcing a polyester resin Copoly 7233 with both woven fabric EWR300 made of E-glass fibres and chopped E-glass fibres. The hand lay-up technology was used to manufacture the specimens with different pressures in the moulding step: low pressure and high pressure, respectively. The first of all, some specimens were immersed in water and the data regarding the moisture content were periodically recorded. Then, the wet composite specimens were subjected to the flexural test (three point method) after 3500 h of immersion and 7417 h of immersion, respectively. Finally, the experimental results obtained in case of the immersed specimens were comparatively analysed with the results recorded in case of the dried specimens subjected to the bending test too. Moreover, the mechanical characteristics of the specimens were analysed taking into account the different manufacture methods used. It is also shown a comparison concerning the results obtained in cases of the two kinds of reinforcements used. Keywords: composite; moisture; absorption; flexural test



Issue: 2009 Volume 46, Issue 2
Pages:
download pdf   Download Pdf Article
Creative Commons License
This article is published under the Creative Commons Attribution 4.0 International License
<<<< back
 
  Search Authors
Crossref Member Badge
 DOI  logo
 Gold Open Access | Source=http://www.plos.org/  | Author=art designer at PLoS
Creative Commons License