MIRCEA DORIN VASILESCU CONSTRUCTIV AND TECHNOLOGICAL CONSIDERATION ON THE GENERATION OF GEAR MADE BY THE DLP 3D-PRINTED METHODE The aim of the work is conduct to highlight how the technological parameters has influence of 3D printed DLP on the generation of wheel, made from resin type material. In the first part of the paper is presents how to generate in terms of dimensional aspects specific design cylindrical gears, conical and worm gear. Generating elements intended to reduce the cost of manufacturing of these elements. Also are achieve the specific components of this work are put to test with a laboratory test stand which is presented in the paper in the third part of the paper. The tested gears generated by 3D-printed technique made with 3D printed with FDM or DLP technique. After the constructive aspects, proceed to the identification of conserved quantities, which have an impact both in terms of mechanical strength, but his cinematic, in order to achieve a product with kinematic features and good functional domain specific had in mind. The next part is carried out an analysis of the layers are generated using the DLP and FDM method using an optical microscope with magnification up to 500 times, specially adapted in order to achieve both visualization and measurement of specific elements. In the end part, it will highlight the main issues and the specific recommendations made to obtain such constructive mechanical elements.